...

Siding Installation and Repair on Long Island, Built for Salt Air And Wind

Most siding failures on Long Island are not the siding. They are what is behind it. Missing housewrap, water management details that were never installed, panels nailed too tight so they cannot move, and flashing at the windows that was skipped because nobody would see it.

Bluemaster Roofing installs, repairs and replaces siding across Nassau County, Suffolk County and Queens  Before we quote a re-side we pull panels and look at the sheathing underneath, because the number changes considerably depending on what is back there. Every estimate is written, itemized and photographed.

Contact Now

Request A Free Siding Estimate

30 Years Of Field Experience
100% Financing Available
GAF Master Elite Certified
Fully Licensed And Insured
Siding Services

The Siding Work We Handle Across Long Island

From a single cracked panel through to a full tear-off and re-side, all handled in-house by one crew.

01

Siding Inspection

We walk the elevations, check the joints, corners, window and door flashing, and pull panels in a few places to see what the sheathing and the water barrier are actually doing. Photographs of every finding, and a written assessment of how much life the siding realistically has left. No charge and no deposit, and you keep the file whether or not you hire us.

02

Siding Repair

Cracked, warped, loose or storm-damaged panels replaced, corner posts and J-channel refixed, and trim details rebuilt. Where a section has failed rather than the whole wall, we quote the section. Being upfront about it: matching twenty-year-old siding is rarely invisible, and we will tell you before we start how noticeable the repair will be.

03

New Siding Installation

New builds, additions, dormers and garages, coordinated with your general contractor so the house gets closed in on schedule. Housewrap, flashing and water management installed as a system rather than as separate line items.

04

Siding Replacement

Full removal down to the sheathing, wall inspected and repaired where the wood is soft, new water-resistive barrier, then new siding installed with proper clearances and fastening. This is where the real difference between contractors sits, and almost all of it is invisible once the last panel goes on.

05

Siding Maintenance

Scheduled cleaning and inspection, caulking renewed at the joints that actually need it, and small failures handled before they let water in. Particularly worth it on the South Shore and out on the forks, where salt and wind work at the details year round.

06

Emergency Siding

Someone answers at any hour. Wind-stripped panels, storm and tree impact, and open wall sections get covered and secured the same day, photographed and documented for your insurer before anything is touched. Permanent repair follows once the weather clears.

Materials

Which siding material is right for your house?

Four options cover almost every Long Island home. Vinyl for most houses, cedar impression vinyl for the shake look without the upkeep, real cedar where a historic district requires it, and fiber cement where wind and salt are the deciding factor. Where the house sits matters as much as what you like the look of.
Vinyl siding Long Island NY
Most installed

Vinyl Siding

The default on Long Island, and for good reason.
Lifespan
30 to 40 years
Maintenance
Wash it, that is all
Coastal
Holds up well
Cost
Most affordable

Right for

Most houses. It does not rot, does not need painting, and modern profiles look nothing like the vinyl people remember from the eighties.
cedar siding Long island ny

Cedar Vinyl Siding

Vinyl moulded into a cedar shake profile.
Lifespan
30 to 40 years
Maintenance
Same as vinyl
Coastal
Holds up well
Cost
Above standard vinyl

Right for

Colonials, capes and anything where you want the shake look on gables or a whole elevation without repainting or replacing shakes in fifteen years.
cedar vinyl siding Long island NY

Cedar Siding

The default on Long Island, and for good reason.
Lifespan
30 to 40 years, maintained
Maintenance
Staining every few years
Coastal
Good, needs stainless fixings
Cost
Premium

Right for

Historic districts, period homes, and anyone who wants real wood grain and the silver-grey weathering that no moulded product reproduces.
Cement Siding Long Island NY

Cement Board Siding

The default on Long Island, and for good reason.
Lifespan
40 to 50 years
Maintenance
Repaint every 10 to 15 years
Coastal
The best of the four
Cost
Premium

Right for

Exposed waterfront elevations, and anywhere fire rating or impact resistance matters. Heavy, so it takes longer to install than vinyl.

On the South Shore, the fixings matter as much as the siding

Salt air works on fasteners and trim metal the same way it works on a roof. Whatever material goes on, the nails, the flashing and the trim need to be corrosion resistant within a mile of the water, or the siding outlives the things holding it up. Tell us the address and we will spec it for your exposure.
Manufacturers

Siding material from the best

We work with two manufacturers rather than whatever the supplier has cheapest that month. Both make siding built for a climate with real winters and real wind, and both back it with a warranty that outlasts most of the companies installing it. Consistency matters more than variety when a house needs matching panels in fifteen years.

CertainTeed Siding Long island ny

CertainTeed Siding

One of the most established names in North American building products, and the one we reach for most often. Their range covers everything on this page except real cedar, which means a whole house can be done in one system with matching trim and corners.

CertainTeed Siding

Colour consistency across production runs. If a panel needs replacing in ten years, it still matches the rest of the house.
Royal Building Solutions Long Island NY

Royal Building Solutions

Heavier gauge panels and deeper profiles, which is what you notice on an exposed elevation. Thicker vinyl holds its shape better in wind and reads less like vinyl from the street, and that difference shows most on a south-facing wall that takes weather all year.

Why we use it

When the house is exposed and the budget allows, the heavier panel is the one that still looks right in fifteen years.

The warranty depends on how it goes on

Every siding warranty on the market is conditional on correct installation. Nailed too tight, vinyl cannot expand and buckles in summer. Nailed too loose, it rattles and works free in wind. Neither is a material fault, and neither is covered. We install to the manufacturer’s spec because that is what makes the certificate at the end mean something.
One Crew, One Junction

Where the roof ends and the wall begins

There is a strip about six inches deep where the roof, the gutter and the siding all meet. Drip edge, gutter apron, fascia, soffit and the top course of siding, all within a hand’s width of each other. Handled by three contractors at three different times, that strip is where water gets in and where nobody takes responsibility.

SHINGLES FASCIA SOFFIT SIDING The junction Roof, gutter and wall all meet here Drip edge Gutter apron Gutter

Water runs off the shingles, over the drip edge and gutter apron, and into the gutter. If any one of those three pieces is wrong, it runs behind the gutter and down the fascia instead.

The roofer says

“The roof is fine. Your gutter is not sealed to the fascia properly.”

The gutter company says

“The gutter is hung correctly. Whoever did the roof left the drip edge short.”

The siding company says

“That fascia was already rotten when we got here. Nothing to do with the siding.”
Three contractors

Separate jobs, separate years

The junction
Nobody owns it. Each trade stops where their scope ends, and the overlap is where water gets in.
When something leaks
Three phone calls, three opinions, and usually nobody comes back.
Setup
Staging goes up three times. Three dumpsters, three disruptions, three sets of crews on your property.
Fascia and soffit rot
Gets noticed by everyone and quoted by nobody, because it sits between two scopes.
One crew

Done together, done once

The junction
One responsibility. Drip edge, apron, gutter, fascia and siding are detailed as a single assembly.
When something leaks
One phone call, and no argument about whose scope it fell in.
Setup
Staging is already up and the crew is already here. One disruption instead of three.
Fascia and soffit rot
Found with the gutter off and the roof edge open, which is the only time you can properly see it.

The cheapest time to do the gutters is while the roof is off

Gutters have to come down for a roof replacement anyway. Putting old gutters back on a new roof is work you pay for twice, once to refit them and again when they come off in a few years.

Siding is a smaller saving but the same logic. The crew, the staging and the dumpster are already on site, and the eave detail only gets built once.

Our Process

How A Siding Project Runs

01

Inspection And Panel Pull

We walk every elevation, check the flashing at windows, doors and rooflines, and pull panels in several places to see the sheathing and the water barrier. Everything is photographed. This is what decides the scope, and it cannot be done from the driveway.

02

Written, Itemized Estimate

Material, profile and color named, sheathing priced per sheet in advance, flashing and trim broken out separately. Financing available up to 100% of project cost, subject to credit approval.

03

Water Barrier, Flashing And Installation

New water-resistive barrier, flashing installed at every window head, door head and roof-to-wall junction, then siding installed with proper fastening and clearances.

04

Cleanup, Walkthrough And Warranty

Debris hauled out, magnet sweep across the property, final walk with you, inspection closed and the manufacturer warranty registered.

Pricing

What Shapes The Cost Of A Siding Job In Long Island

Wall area sets the floor. What moves it is the material you choose, how many stories, how much trim and detail the house has, what condition the sheathing is in once the old siding comes off, and how much staging the elevations need.

Wall area and number of stories.

A two-story colonial needs staging on every elevation. A ranch of the same square footage is worked from ladders and finishes considerably faster.

Material choice.

Vinyl, insulated vinyl, engineered wood, fiber cement and cedar sit at very different price points, and the labor differs as much as the material does. Fiber cement is heavy and slow to hang. Cedar is slower still.

Sheathing condition

The largest unknown, and the one we establish before pricing rather than after. Priced per sheet in advance and photographed as it is replaced.

Flashing and water management

Window and door head flashing, kick-out flashing at roof-to-wall junctions, and a proper water barrier. On many older Long Island houses none of it exists and it all goes on new.

Siding Installation and Repair on Long Island, Built for Salt Air and Wind
Why Choose Us

What You Get On A Siding Job

Siding is where the least accountable work in the exterior trades happens, because the wall gets covered over and nobody can check. These are the things we do so that is not true here.

We pull panels before we quote.

The sheathing decides the scope and the price. Quoting a re-side without looking behind the siding is guessing with your money.

The estimate is the invoice

Sheathing priced per sheet in advance, photographed as replaced. No allowances that expand once the wall is open.A written, itemized quote with no vague allowances or surprise add-ons once work begins.

Water management installed as a system

Barrier, window and door head flashing, kick-out flashing at roof-to-wall junctions, and correct clearances. These are the six details that actually keep a wall dry, and they are the first things cut from a cheap quote.

Panels hung, not clamped

Vinyl has to move. The buckled, wavy walls you see across this island are almost always fastening rather than product.

Who We Serve

The Long Island Homes We Side

This island was built in waves and each wave left its own siding problem behind. These are the situations we get called for most.

Cement Siding Long Island NY
Roofing Services

Other Roofing Services We Provide Across Long Island

Siding and roofing meet at the walls, the gables and the kick-out flashing, which is why doing both together usually costs less than doing them two years apart. Every service below is handled by the same in-house crew.

Roofing Systems

Roofing Systems We Maintain And Install

If the siding is going, the roof is frequently close behind, because both went on the same year. We install and warranty all six.

FAQ's

Siding Questions Long Island Homeowners Ask

Cost, going over the old siding, asbestos, salt exposure and timing with the roof. These five come up on nearly every siding estimate.

Can you install new siding over the old siding?

Sometimes, and it costs less, but it is the wrong call more often than not. Going over means nobody ever sees the sheathing, you cannot install a proper water barrier, and you cannot flash the windows and doors correctly because the new siding sits proud of them. If the wall behind has been wet for years, covering it seals the problem in. We quote both ways where a layover is genuinely viable so you can see the difference.

Stop and have it tested before anyone touches it. Asbestos cement siding is common on older Long Island homes and it is harmless while intact, but cutting, breaking or removing it releases fibers. Removal is regulated work that has to be done by a licensed abatement contractor, and that is not us. We will tell you if we suspect it, and we will not start a tear-off on a wall we have not confirmed is safe to remove.

Fiber cement and properly installed vinyl both perform well. What actually fails near the water is the metal: the nails, the flashing and the fasteners behind the panels. On the South Shore, the Rockaways and out on both forks we specify corrosion-resistant fasteners and flashing throughout, because standard hardware rusts through years early that close to the ocean and takes the wall with it.

Not much on its own, and we would rather say so than let you find out afterward. Insulated siding adds some value, but attic insulation and air sealing do considerably more per dollar spent, because most heat loss in a Long Island house goes up rather than sideways. If comfort and bills are your actual goal, do the attic first and the siding when the siding needs doing.

If both are near the end of their life, yes, and the saving is real rather than a sales line. Staging goes up once instead of twice, one permit and one disposal cycle, and crucially the roof-to-wall flashing and the kick-out details get done properly as one system. When those two trades happen years apart, that junction is where they meet badly and where leaks start.

Find Out What Is Actually Behind Your Siding

We pull panels, check the sheathing and the water barrier, and tell you honestly whether you are looking at a repair or a full re-side. Free inspection, photographs of every finding, an itemized written estimate, and financing available up to 100% of project cost, subject to credit approval. Bluemaster Roofing serves Nassau County, Suffolk County and Queens from 141 Main Street, East Rockaway, NY. Ask about our military and government employee discounts.

Book Your Free Inspection